chip mounter operation and machine failure
This surface mounting machine has been widely used in industrial production in recent deCADes It can bond and position parts High effICiency is the most critical and complex SMT equipment in all production However, the paving process of this machine is too complicated, so we need to explain the operation method of the paving machine carefully for everyone
1. The testing machine and the mounter is a SMArt machine, which will help us to save some updated data. Therefore, we need to check the mounter system before using the machine, first of all, whether the hardware air supply, power supply and emergency button are normal, whether the safety cover of the laminator is covered, whether the suction nozzle is damaged or offset, clean the interior and the paper machine, and then we need to check the software and programs to see if we need to do this.
2. Recovery operation: For the operation of the patch machine software, we need to first check the software, open the system, and then select "Return to the machine origin" in the menu, so that our patch machine will automatically return to the origin and wait for the next operation
Circuit board

3. Preheating operation: thermal operation can help the machine "burn quickly", which is a function that we must enable before assembly, so that the assembly machine can enter the state quickly, so that the assembly is more accurate and faster. Generally, we can set the heating time to 10-15 minutes, and then perform the installation task after the waiting time.
4. Patch production: The task of patch production is one of the most important tasks in our entire system. We need to inspect and process products by machines.
5. Production data: After installation, we can conduct production data. Press F2 on the keyboard to select the production data to be produced. After selection, the nozzle type of each master device required to display data on the operation screen will be determined one by one.
Most of the time, we are prone to many errors in the operation and use of the SMT machine. This not only reduces our production efficiency, but also affects the production process, avoiding thousands of products. We ask the invention to show you some common errors, which will lead to many wrong placement of the machine. We must correctly avoid these failures, which will make our machine work better. Let's have a look.
1： It is an error if the data is in place when it is set. We need to calibrate the working position accurately. Since there are many machines in the puller, this position is incorrect. If there is a problem, please paste a common distortion., We must correct it immediately and check it every time we use the mounter.
Second 2: If we want to use our methods to change the operation of data on the SMT machine, it will not only affect the operation of the machine and the failure of the paver, but also threaten our lives, the emergency replacement of data and the emergency braking of the machine, so as to ensure personal safety
Third: When SMT is working, we cannot deeply insert our body into SMT. If you need to observe the operation, you must close the security window and look out. If an accident occurs, we must shut it down in an emergency.
4： Our computer has a problem with the surface mount machine SMT usually likes to check the effect This is a good operation However, many bad PCBA factories found defective data after inspection and conducted secondary processing, not only the data were the same This is a huge loss, which also misleads consumers. We reject inferior products

The above is the explanation given by the editor of PCB circuit board company.
If you want to know more about PCBA, you can go to our company's home page to learn about it.
In addition, our company also sells various circuit boards,
High Frequency Circuit Board and SMT chip are waiting for your presence again.